Spec-Finish^® is the cost-effective high-performance coated masonry wall system.

Spec-Finish^® combines special smooth and tight textured SPEC-SURFACE™ block from CPG with high performance coatings from Tnemec. SPEC-SURFACE may also be used with ordinary paint coatings.

SPEC-FINISH® System Levels

FOUR CHEMICAL-RESISTANT, HIGH-PERFORMANCE FINISH LEVELS TO MEET A VARIETY OF AESTHETIC AND PERFORMANCE REQUIREMENTS

Standard Block Finish (Level I)

Cost-Effective for Lighter Duty Applications

Orange Peel Block Finish (Level II)

Pin-Hole Free Surface for greater cleanability

Smooth Block Finish (Level III)

Pin-Hole Free Surface with Smooth Finish

Smooth Block Finish (Level IV)

Pin-Hole Free Surface with Minimal Joint Appearance

Advantages:

SPEC-FINISH blocks are made with a special mix design including a pre-conditioner that results in an especially tight and smooth surface texture.
SPEC-FINISH walls offer superior performance for applications with exacting hygienic requirements - both the block and mortar joints are fully coated, and the coatings may also be applied to flooring and ceilings to provide comprehensive coverag

Spec-Surface™

Resources:

Additional Info:

Construction Efficiency

The smooth and tight surface texture results in labor and time savings when compared to using traditional CMU by minimizing need for block filler layers prior to painting or coating.
SPEC-FINISH is significantly less expensive than alternate approaches for its intended applications, such as glazed tile or CMU.